West Sussex
Microcement in Horsham
Horsham sits just west of Crawley, close enough that our team is in and out of the town regularly. Most Horsham enquiries we see are about floors, so this page concentrates there.
What a Horsham microcement floor involves
A floor is built in stages: the substrate is checked and prepared, a primer and mesh go down where needed, then base coats, finishing coats and a protective sealer. Colour is signed off on your own floor rather than from a small chip.
Expect around four to six working days on site for a typical floor. Light foot traffic is possible after 24 to 48 hours, with roughly seven days before full use, so plan furniture moves around that.
It is not the answer everywhere. Garages, workshops and plant rooms take hot tyres, oils and heavy point loads, and for those we specify a resin or epoxy system instead.
Colour choice matters more on a floor than people expect, because a large area reads darker than a sample. We lay test patches in your room, look at them in daylight and artificial light, and only then mix the full batch. We keep a record of the pigment and batch so any later repair matches.
From the Causeway to North Heath: matching the finish to the house
Horsham's housing spans centuries. The Causeway has 17th- to early 19th-century houses, New Town grew quickly in the early Victorian period, and North Heath and Holbrook were built in the late 20th century. The town centre and the London Road, Richmond Road and Park Terrace Gardens areas are conservation areas, and older walls there often suit breathable limewash rather than a sealed coating. The later suburbs are where contemporary microcement bathrooms, kitchens and floors fit most naturally. Across the district, more than a third of homes are detached and most are owner-occupied, so whole-house finish schemes are common. See limewash wall coatings or microcement bathrooms.
Epoxy, resin and garage flooring in Horsham
Alongside microcement we lay epoxy resin flooring, polyurethane flooring and industrial floor coatings in Horsham, for domestic garages, workshops and commercial units. These are a different product from microcement: the slab is tested and mechanically prepared, then the system is chosen for the traffic and the downtime available. Domestic garage flooring in Horsham follows our garage floor coating specification, and heavier units follow industrial floor coatings. Shops around the Carfax and Swan Walk can take a resin or microcement floor, depending on footfall.
Tanking and wet rooms
In a Horsham wet room or shower, the shower zone is tanked with a flexible cementitious membrane before any microcement goes on, because the tanking is the waterproofing and the microcement is the finish. Horsham's water is slightly hard, so a squeegee after showering and a pH-neutral cleaner keep limescale off the sealed surface. See microcement showers for the full build.
We have no published Horsham project on this site yet. Our gallery shows finished floors from elsewhere in Sussex, Surrey and London.
Horsham: straight answers
- Will it work with underfloor heating?
- Yes, microcement is commonly laid over underfloor heating. Our guide covers the heating-off period and commissioning.
- Can it go over my existing tiles?
- Usually. Sound, well-bonded tiles can be prepared and coated, avoiding a strip-out.
- Do you do resin and epoxy floors in Horsham too?
- Yes. Epoxy, polyurethane and polyaspartic systems for garages, workshops and commercial units, specified after testing the slab.
- Is my Horsham home in a conservation area?
- The town centre, London Road, Richmond Road and Park Terrace Gardens areas are conservation areas, and some Article 4 directions apply. Internal finishes rarely need permission, but listed buildings can, so check with Horsham District Council if yours is listed.
- How do I look after it?
- Sweep or vacuum and clean with a pH-neutral cleaner. The sealer does the stain resistance.
Tell us about the space.
Free site visits across Sussex, Surrey, Kent, Hampshire and London. No obligation.